Diodes Incorporated — Analog and discrete power solutions
Back to Bus Switches

PI3USB102E

Dual SPDT for USB 2.0 HS Compliance and Flow Through Pinout with 5V Protection

Contact Sales

Log in or register to manage email notifications about changes to datasheets or PCNs for this part.

Product Description

The PI3USB102E is a single differential channel 2:1 multiplexer/ demultiplexer USB 2.0 Switch. Industry leading advantages include a propagation delay of 250ps, resulting from its low channel resistance and I/O capacitance. PI3USB102E is bidirectional and offers very little attenuation of high-speed signals. It is designed for low bit-to-bit skew, high channel-to-channel noise isolation and is compatible with various standards, such as High Speed USB 2.0 (480 Mb/s). The PI3USB102E offers over voltage protection for the Y+/Y- pins as per the USB 2.0 specification. With the chip powered on or off if Y+/Y- pins are shorted to VBUS (5V +/- 5%), M+/M- and D+/Doutputs are clamped to provide voltage protection for downstream devices.

Features

  • USB 2.0 compliant (high speed, full speed, and low speed)
  • RON: 4.0Ω typical @ VDD = 3.0V
  • Channel On Capacitance: 6.0pF
  • Wide -3dB Bandwidth: 1,000MHz
  • Low bit-to-bit skew
  • Low Crosstalk: -29B @ 480 Mbps
  • Off Isolation: -28dB @ 480 Mbps
  • Near-Zero propagation delay: 250ps
  • Support 1.8-V logic on control pins
  • VDD Operating Range: 3.0V to 5.5V
  • ESD: 8kV HBM on Y+/Y- pins per JESD22 standard
  • Y+/Y- pins have over-voltage protection and can tolerate a short to VBUS
  • Packaging (Pb-free & Green): 10-contact TQFN, 1.3mm x 1.6mm x 0.75mm (ZL10)

Application

  • Routes signals for USB 2.0
  • PC, Notebooks and Hand-held devices

Product Specifications

Product Parameters

Configuration 1-Differential Channel 2:1
Differential Channels N/A
HotInsertion 0
Lanes 1
OtherFeatures N/A
Rail-to-Rail 0
Signal Type Differential
Single Ended Channels N/A
Type SPDT
Voltage 3.3

Technical Documents

Design tool model software

Recommended Soldering Techniques

TN1.pdf

Additional Technical Documents are available upon request: 
Application information, Evaluation board, and Other technical documents

Request Documents

Product Change Notices (PCNs)

A PCN may only apply to specific orderable part numbers in this datasheet. Please refer to the corresponding PCN to see the exact orderable part number(s) affected.

PCN # Issue Date Implementation Date Subject
PCN-2651 2023-11-13 2023-11-13 Qualified Additional Fab Source, Assembly Test Sites, Die Revision, BOM, Datasheet, Tape and Reel Packing Quantity.