PI4GTL2002

Description

The Gunning Transceiver Logic - Transceiver Voltage Clamps (GTL-TVC) provide high-speed voltage translation with low ON-state resistance and minimal propagation delay.

The DIODES PI4GTL2002 provides 2 NMOS pass transistors (Sn and Dn) with a common gate (GREF) and a reference transistor (SREF and DREF). The device allows bidirectional voltage translations between 0.8V and 5.0V without use of a direction pin.

When the Sn or Dn port is LOW the clamp is in the ON-state and a low resistance connection exists between the Sn and Dn ports. Assuming the higher voltage is on the Dn port, when the Dn port is HIGH, the voltage on the Sn port is limited to the voltage set by the reference transistor (SREF). When the Sn port is HIGH, the Dn port is pulled to VCC by the pull-up resistors. This functionality allows a seamless translation between higher and lower voltages selected by the user, without the need for directional control.

All transistors have the same electrical characteristics and there is minimal deviation from one output to another in voltage or propagation delay. This is a benefit over discrete transistor voltage translation solutions, since the fabrication of the transistors is symmetrical. Because all transistors in the device are identical, SREF and DREF can be located on any of the other two matched Sn/Dn transistors, allowing for easier board layout. The translator's transistors provide excellent ESD protection to lower voltage devices and at the same time protect less ESD-resistant devices.

Feature(s)

• 2-bit bidirectional translator
• Less than 1.5ns maximum propagation delay to accommodate Standard mode and Fast mode I2C-bus devices and multiple masters
• Allows voltage level translation between 0.8V, 1.2V, 1.5V, 1.8V, 2.5V, 3.3V and 5V buses, which allows direct interface with GTL, GTL+, LVTTL/TTL and 5V CMOS levels
• Provides bidirectional voltage translation with no direction pin
• Low 3.50Ω ON-state connection between input and output ports provides less signal distortion
• Supports hot insertion
• 5 V tolerant inputs
• Flow-through pinout for ease of printed-circuit board trace routing
• ESD protection exceeds 4KV HBM per JESD22-A114
• Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
• Halogen and Antimony Free. "Green" Device (Note 3)
• For automotive applications requiring specific change control (i.e. parts qualified to AEC-Q100/101/104/200, PPAP capable, and manufactured in IATF 16949 certified facilities), please contact us or your local Diodes representative.
• https://www.diodes.com/quality/product-definitions/
• Packaging (Pb-free & Green):
• 8-Pin, MSOP (M)
• 8-Pin, VSSOP (V)
• 8-Pin, X2-DFN (HK)
• 8-Pin, SOT28 (TA)
• 8-Pin, SSOP (SS)