NRND = Not Recommended for New Design
3.3V, 1-port SATA3i ReDriver with Digital Configuration, Standby Auto Slumber Mode, and HDD Detect Power Saving Mode
Contact Sales
Log in or register to manage email notifications about changes to datasheets or PCNs for this part.
PI3EQX6741ST is a low power, signal SATA Gen 3i 6Gbps ReDriver. The device provides programmable equalization and output emphasis, to optimize performance over a variety of physical mediums by reducing Inter-Symbol Interference. PI3EQX6741ST supports two 100Ω Differential CML data I/O’s between the Protocol ASIC to a switch fabric, across a backplane, or to extend the signals across other distant data pathways on the user’s platform.
The integrated equalization circuitry provides flexibility with signal integrity of the signal before the ReDriver.
A low-level input signal detection and output squelch function is provided for each channel. Each channel operates fully independently. When the channels are enabled (EN=1) and operating, that channels input signal level (on xI+/-) determines whether the output is active. If the input signal level of the channel falls below the active threshold level (Vth) then the outputs are driven to the common mode voltage.
Termination Detect indication (TDet_A# or TDET_B#) provides indication when the load is connected ie HDD or Host. This can be used as control to go into power saving mode by either the host or HDD.
In addition to signal conditioning, when EN = 0, the device enters a low power standby mode.
| Compliance (Only Automotive supports PPAP) | Standard |
|---|---|
| Channels | 2 |
| Data Rate (Gbps) | 6 |
| Lanes/Ports | 1 |
| Output Swing Max (mV) | 600 |
| Programming Interface(s) | Pinstrap |
Additional Technical Documents are available upon request:
Application information, Evaluation board, and Other technical documents
A PCN may only apply to specific orderable part numbers in this datasheet. Please refer to the corresponding PCN to see the exact orderable part number(s) affected.
| PCN # | Issue Date | Implementation Date | Subject |
|---|---|---|---|
| PCN-2672 | 2024-03-11 | 2024-09-07 | Device End of Life (EOL) |
| PCN-2520 | 2021-05-27 | 2021-08-27 | Qualified Additional Bump Site and Assembly/Test (A/T) Sites |
| PCN-2328 | 2018-04-12 | 2018-10-12 | Device End of Life for tray packaging only |
